Dishwasher Faults

If you need further help you can e-mail us with your question

Not showing any power –

  • Check the fuse – Might blow the fuse if there is a leak or wires make bad contact
  •  Mains suppressor failure
  • Multi pin connectors loose at the circuit board
  • Door catch or On/Off button fault or related components fault

Power on but nothing happens-

  • Drain pump fault
  • Circuit board or timer fault
  • Door catch or On/Off button faulty or related components fault
  • Inlet valve fault
  • Water level sensor fault

Water continuously draining at the start-

  • Flood sensor activated. Possibly a leak into the base.
  • Water level sensor fault
  • Drain pipe too low
  • Water Enters at the start then stops-
  • Motor fault
  • Motor capacitor failure
  • Heating Element or thermostat fault

Water Enters at the start then stops & starts many times-

  • Gunge in the pipes in the base  or water flow chamber

Water will not drain-

  • Drain pump fault
  • Possible blockage in the drain pipe
  • Possible obstruction to the drain pump impellor. Usually chicken bone or glass

Water will not enter at the start-

  • Gunge in the pipes in the base  or water flow chamber
  • Inlet valve fault
  • Water level sensor fault

Wash cycle runs but dishes not properly clean-

  • Gunge in the pipes in the base  or water flow chamber
  • Heating Element or thermostat fault
  • Spray arms blocked
  • Filter blocked

White Goods Spares